Wan Port Configuration Using Ipoa - Symmetricom GoWide 4.6 User Manual

S S S S S S S S S

WAN Port Configuration using IPOA

Refer to Procedure L for information on configuring the WAN Port using IPOA.
Procedure L. Configuring WAN Port Using IPOA
Step
1
Select IPOA in the System Menu (Figure 41).
2
Enter the VPI value in the VPI field.
3
Enter the VCI value in the VCI field.
4
Select the Quality of Service type: UBR (default setting), CBR, or VBR. A pop-up screen appears. Enter the
appropriate information.
5
Enter the values for Local IP, Subnet Mask, and Gateway in the respective fields.
6
Select either Set as Default Route, Edit Routing Table, or RIP under Routing Table (RIP is the default setting).
7
If NAT is desired, click the NAT box under Advanced.
8
Click the Apply button if all data is correct.
GoWide 4.6 G.shdsl Bridge/Router – User Manual
Router Mode Configuration
097-91022-01 Issue 1: February 2002
S S S S S S S S S
End of Procedure
S S S S S S S S S
Procedure
S S S S S S S S S
2
3
5
S S S S
1
4
4
67