Wan Port Configuration Using Pppoe Client - Symmetricom GoWide 4.6 User Manual

S S S S S S S S S

WAN Port Configuration using PPPoE Client

Refer to Procedure O for information on configuring the WAN Port using PPPoE
Client.
Procedure O. Configuring WAN Port Using PPPoE Client
Step
1
Select PPPoE Client in the System Menu (Figure 44).
2
Enter the VPI value in the VPI field.
3
Enter the VCI value in the VCI field.
4
Select the Quality of Service type: UBR (default setting), CBR, or VBR. A pop-up screen appears. Enter the
appropriate information.
5
Select either None, CHAP, or PAP under Authentication (None is the default setting).
6
Enter a numerical value in the Time Out field.
7
If specifying a local IP address is desired, click the Specify an IP Address box under Local IP.
8
Enter a value in the Subnet Mask field.
9
Enter a value in the AC Name field.
10
Enter a value in the Service Name field.
11
If RIP is not desired under Routing Table, deselect the box (RIP Allowed is the default setting).
12
If NAT is desired, click the NAT box under Advanced.
13
Click the Apply button if all data is correct.
GoWide 4.6 G.shdsl Bridge/Router – User Manual
Router Mode Configuration
097-91022-01 Issue 1: February 2002
S S S S S S S S S
End of Procedure
S S S S S S S S S
Procedure
S S S S S S S S S
2
3
5
S S S S
1
4
4
73