Wan Port Configuration Using Rfc1483 - Symmetricom GoWide 4.6 User Manual

S S S S S S S S S

WAN Port Configuration using RFC1483

Refer to Procedure U for information on configuring the WAN Port using RFC1483.
Procedure U. Configuring WAN Port Using RFC1483
Step
1
Select RFC1483 in the System Menu (Figure 66).
2
Enter the VPI value in the VPI field.
3
Enter the VCI value in the VCI field.
4
Select the Quality of Service type: UBR (default setting), CBR, or VBR. A pop-up screen appears. Enter the
appropriate information.
5
Select the Encapsulation type: LLC (default setting) or VCMUX.
6
If obtaining an IP automatically is desired, click the Obtain an IP automatically box under Local IP.
Otherwise, enter a value for the Local IP in the provided field.
7
Enter the values for Subnet Mask and Gateway in the provided fields.
8
Select either Set as Default Route or Edit Routing Table under Routing Table (Set as Default Route is the
default setting).
9
If NAT is desired, click the NAT box under Advanced.
10
Click the Apply button if all data is correct.
GoWide 4.6 G.shdsl Bridge/Router – User Manual
Gateway Mode Configuration
097-91022-01 Issue 1: February 2002
S S S S S S S S S
End of Procedure
S S S S S S S S S
Procedure
S S S S S S S S S
2
3
5
S S S S
1
5
101