Hardware Installation - Symmetricom GoWide 4.6 User Manual

S S S S S S S

Hardware Installation

Figure 3. GoWide 4.6 Rear Panel Cable Connections
2
Procedure A. PC Connection to the Ethernet Port
Step
1 Check that the Ethernet card and the TCP/IP protocol are installed on the PC before beginning installation. (If
the TCP/IP protocol is not installed, go to Appendix A for the installation procedures.)
2 Connect the Ethernet cable from any of the four GoWide 4.6 Ethernet ports to the PC's NIC card or the
server's NIC card.
3 Connect one end of the DSL cable to the DSL wall jack and the other end to the "DSL" RJ-11 receptacle on the
back of the GoWide 4.6.
4 Connect one end of the power cord to the wall jack and the other end to the "AC POWER" receptacle on the
GoWide 4.6.
Turn on the GoWide 4.6 by placing the ON/OFF switch in the ON position. The Power LED must be a steady
green. The Sync LED will initially be a blinking green. Once the connection is established, the Sync LED will
5 become a steady green.
20
S S S S S S S S S
Figure 3 shows the cable connections to the GoWide 4.6 rear panel. Connecting the
PC to the Ethernet port is described in Procedure A.
AC POWER
S S S S S S S S S
ETHERNET
Procedure
End of Procedure
S S S S S S S S S
DSL
GoWide 4.6 G.shdsl Bridge/Router – User Manual
097-91022-01 Issue 1: February 2002
S S S S S S
Installation