NETGEAR SRX5308 Reference Manual page 61

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
3. Enter the settings as explained in the following table:
Table 12. Edit VLAN Profile screen settings
Setting
VLAN Profile
Profile Name
VLAN ID
Port Membership
Port 1
Port 2
Port 3
Port 4 / DMZ
IP Setup
IP Address
Subnet Mask
DHCP
Disable DHCP
Server
Description
Enter a unique name for the VLAN profile.
Note: You can also change the profile name of the default VLAN.
Enter a unique ID number for the VLAN profile. No two VLANs can have the same
VLAN ID number.
Note: You can enter VLAN IDs from 2 to 4093. VLAN ID 1 is reserved for the default
VLAN; VLAN ID 4094 is reserved for the DMZ interface.
Select one, several, or all port check boxes to make the ports members of this VLAN.
Note: A port that is defined as a member of a VLAN profile can send and receive
data frames that are tagged with the VLAN ID.
Enter the IP address of the VPN firewall (the factory default is 192.168.1.1).
Note: Always make sure that the LAN port IP address and DMZ port IP address are
in different subnets.
Note: If you change the LAN IP address of the VLAN while being connected through
the browser to the VLAN, you will be disconnected. You then need to open a new
connection to the new IP address and log in again. For example, if you change the
default IP address 192.168.1.1 to 10.0.0.1, you now need to enter https://10.0.0.1 in
your browser to reconnect to the web management interface.
Enter the IP subnet mask. The subnet mask specifies the network number portion of
an IP address. Based on the IP address that you assign, the VPN firewall
automatically calculates the subnet mask. Unless you are implementing subnetting,
use 255.255.255.0 as the subnet mask (computed by the VPN firewall).
If another device on your network is the DHCP server for the VLAN, or if you will
manually configure the network settings of all of your computers, select the Disable
DHCP Server radio button to disable the DHCP server. This is the default setting.
LAN Configuration
61