NETGEAR SRX5308 Reference Manual page 30

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Table 3. PPTP and PPPoE settings (continued)
Setting Description
Austria (PPTP) Server IP
(continued) Address
Other (PPPoE) If you have installed login software, then your connection type is PPPoE. Select this radio
button and enter the following settings:
Account Name
Domain Name
Idle Timeout
Connection
Reset
7. In the Internet (IP) Address section of the screen, configure the IP address settings as
explained in the following table. Click the Current IP Address link to see the currently
assigned IP address.
Figure 15.
The IP address of the PPTP server.
The valid account name for the PPPoE connection.
The name of your ISP's domain or your domain name if your ISP has
assigned one. You can leave this field blank.
Select the Keep Connected radio button to keep the connection
always on. To log out after the connection is idle for a period of time,
select the Idle Timoute radio button and, in the timeout field, enter the
number of minutes to wait before disconnecting. This is useful if your
ISP charges you based on the period that you have logged in.
Select the Connection Reset check box to specify a time when the
PPPoE WAN connection is reset, that is, the connection is
disconnected momentarily and then reestablished. Then enter the
following settings:
Disconnect Specify the hour and minutes when the connection
Time should be disconnected.
Delay Specify the period in seconds after which the connection
should be reestablished.
Connecting the VPN Firewall to the Internet
30