NETGEAR SRX5308 Reference Manual page 139

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Figure 78.
2. Complete the settings as explained the following table:
Table 29. IPSec VPN Wizard settings for a gateway-to-gateway tunnel
Setting
About VPN Wizard
This VPN tunnel will connect to
the following peers
Connection Name and Remote IP Type
What is the new Connection
Name?
What is the pre-shared key?
This VPN tunnel will use
following local WAN Interface:
Enable RollOver?
End Point Information
What is the Remote WAN's IP
Address or Internet Name?
Virtual Private Networking Using IPSec Connections
Description
Select the Gateway radio button. The local WAN port's IP address or
Internet name displays in the End Point Information section of the screen.
Enter a descriptive name for the connection. This name is used to help
you to manage the VPN settings; the name is not supplied to the remote
VPN endpoint.
Enter a pre-shared key. The key needs to be entered both here and on
the remote VPN gateway. This key needs to have a minimum length of
8 characters and should not exceed 49 characters.
From the drop-down list, select one of the four WAN interfaces of the VPN
firewall to specify which WAN interface the VPN tunnel uses as the local
endpoint.
If you have configured the VPN firewall to function in WAN auto-rollover
mode (see Configure the Auto-Rollover Mode and Failure Detection
Method on page 34), select the Enable RollOver? check box. Then, from
the corresponding drop-down list, select the backup WAN interface. After
an auto-rollover has occurred, the VPN tunnel will be reestablished using
the backup WAN interface.
a
Enter the IP address or Internet name (FQDN) of the WAN interface on
the remote VPN tunnel endpoint.
139