Problems With Date And Time - NETGEAR SRX5308 Reference Manual

Figure 181.
The VPN firewall reboots. During the reboot process, the Settings Backup and Firmware
Upgrade screen might remain visible. The reboot process is complete after several minutes
when the Test LED on the front panel goes off.
WARNING!
When you press the Factory Defaults Reset button on the rear
panel or click the software Default button, the VPN firewall
settings are erased. All firewall rules, VPN policies, LAN and WAN
settings, and other settings are lost. Back up your settings if you
intend on using them.
Note: After rebooting with factory default settings, the VPN firewall's
password is password, and the LAN IP address is 192.168.1.1.

Problems with Date and Time

The Time Zone screen displays the current date and time of day (see
Time Service on page 262). The VPN firewall uses the Network Time Protocol (NTP) to
obtain the current time from one of several network time servers on the Internet. Each entry in
the log is stamped with the date and time of day.
Problems with the date and time function can include:
• Date shown is January 1, 2000. Cause: The VPN firewall has not yet successfully
reached a network time server. Check that your Internet access settings are configured
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Troubleshooting and Using Online Support
302
Configure Date and