NETGEAR SRX5308 Reference Manual page 132


To add a port triggering rule:
1. Select Security > Port Triggering. The Port Triggering screen displays. (See the
following figure, which shows one rule in the Port Triggering Rules table as an example.)
Figure 71.
2. Below Add Port Triggering Rule, enter the settings as explained in the following table:
Table 27. Port Triggering screen settings
Setting
Name
Enable
Protocol
Outgoing (Trigger)
Port Range
Incoming (Response)
Port Range
3. Click the Add table button. The new port triggering rule is added to the Port Triggering Rules
table.
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Description
A descriptive name of the rule for identification and management purposes.
From the drop-down list, select Yes to enable the rule. (You can define a rule but not
enable it.) The default setting is No.
From the drop-down list, select the protocol to which the rule applies:
• TCP. The rule applies to an application that uses the Transmission Control
Protocol (TCP).
• UDP. The rule applies to an application that uses the User Control Protocol
(UCP).
Start Port The start port (1–65534) of the range for triggering.
End Port The end port (1–65534) of the range for triggering.
Start Port The start port (1–65534) of the range for responding.
End Port The end port (1–65534) of the range for responding.
Firewall Protection
132