Table of Contents
Advertisement
Screws A, B, C and D (M4) : upper
fixation latch. nutdriver 7mm.
Screw A', B', C' and D' (M4) : lower
fixation latch. nutdriver 7mm.
Loosen the two hexagon screws A and A' upper and lower fixation latch.
tube.
Pivot the red CRT until the center of the red image coincides with the center of the green image.
pivot, loosen also screw B a little bit.
ENTER continues to blue and green crosshairs.
EXIT will return to CRT projection angle adjustment.
Loosen the two hexagon screws D and D' upper and lower fixation latch.
tube.
Pivot the blue CRT until the center of the blue image coincides with the center of the green image.
loosen also screw C a little bit.
ENTER continues to the path selection menu.
EXIT returns to the CRT projection angle adjustment.
After finishing the installation adjustments procedure,
R5975819.05 BARCO CINE 6 21112002 ____________________________________________________________________________ 7-7
If the angle of the red CRT is corrected,
red crosshair
green crosshair
Move the red CRT to-
wards the green CRT
red crosshair
Move the red CRT
to
green crosshair
away
green CRT
If the angle of the blue CRT is corrected,
blue crosshair
Move the blue CRT
green crosshair
to
away
green CRT.
blue crosshair
Move the blue CRT
towards the green
green crosshair
CRT.
D
C
B
A
These screws fasten the cooling house of the red
These screws fasten the cooling house of the blue
the
outside,
from
the
the 'Path selection' returns on the screen.
the
outside,
from
the
Installation Adjustments
tighten the bolts again.
CRT PROJECTION ANGLE
ADJUSTMENT
Align crosshairs
<ENTER> continue
<EXIT> to return.
If the tube is hard to pivot,
tighten the bolts again.
You are now able to start the
CRT PROJECTION ANGLE
ADJUSTMENT
Align cross hairs
<ENTER> to continue
<EXIT> to return.
If the tube is hard to
Advertisement
Table of Contents
