4
Access to Controls
Opening procedure
During the projector set up and installation it is necessary to remove the side and top covers.
First remove the top cover, covering the lenses :
•
Turn both lock screws counter clockwise until they are raised by the springs.
•
Lift up the cover and remove.
To remove the second top cover, covering the electronics, first the side covers have to be removed.
Removing the side covers :
•
Turn out the two black screws on the bottom of the side covers.
•
Tilt the side cover and lift it up.
•
Repeat the same for the other side cover.
Removing the second top cover :
•
Loosen the four M4 screws.
•
Slide the cover a few to the back and lift up.
R5975819.05 BARCO CINE 6 21112002 ____________________________________________________________________________ 4-1
INSTALLATION SET UP
Installation Set Up