6
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector
at the front of the projector.
Stand By / Operational
Pause
Sync
Hold Down EHT
IR
Input power (mains) voltage adaptation
Attention
The BARCO CINE 6 - R9002372 leaves the factory with a PFC module to operate on a mains (power) input from 110Vac to 230Vac.
Fuses
Warning :
For continued protection against fire hazard :
- replace with the same type of fuse
- refer replacement to qualified service personnel
Fuse type : 2 x T5A/250V
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed
: ON
Not
pressed : OFF
The projector can start now in the 'operational mode' (image displayed) or in the 'stand by mode' (see projector set up)
Stand by indication lamp :
Green : projector in operational mode
Red
: projector is in stand by.
R5975819.05 BARCO CINE 6 21112002 ____________________________________________________________________________ 6-1
POWER CONNECTION
(Barco order number : R314104)
Power Connection
120 / 230 V
4 A / 2.5 A
60 / 50 Hz
300 W