Configuring The Date Display Format - Kenwood TS-990S Instruction Manual

15 CLOCK DISPLAY AND TIMER
CONFIGURING THE TIMEZONE FOR THE LOCAL
CLOCK
You can configure the timezone of Local Clock to be
displayed on the main screen. The time calculated based
on the time configured here will be displayed on the right
side of Local Clock as the time for Secondary Clock.
1 Press [CLOCK] (F) from the Menu screen to open the
Clock screen.
2 Access Menu 00, "Date and Time".
3 Press [SELECT] (F4).
4 Access Menu 02, "Timezone (Local Clock)".
5 Press [SELECT] (F4) to allow editing of the parameter
box.
6 Press [-] (F2), [+] (F3), or rotate the MULTI/CH control
to select the timezone for Local Clock.
The default is "+00:00".
7 Press [ ] (F1).
8 Press [MENU] to exit.
CONFIGURING THE TIMEZONE FOR THE SECONDARY
CLOCK
You can configure the timezone for Secondary Clock.
1 Press [CLOCK] (F) from the Menu screen to open the
Clock screen.
2 Access Menu 00, "Date and Time".
3 Press [SELECT] (F4).
4 Access Menu 03, "Timezone (Secondary Clock)".
5 Press [SELECT] (F4) to allow editing of the parameter
box.
15-2
6 Press [-] (F2) or [+] (F3), rotate the MULTI/CH control
to select the time zone for the secondary clock from
the available range from "-14:00" to "+00:00" to
"+14:00".
The default is "+00:00"
7 Press [ ] (F1).
8 Press [UPDATE] (F6) to confirm whether the time has
been updated.
The transceiver begins to communicate to the NTP server,
and the date and time configured for the transceiver will be
updated. After the correction has completed, a message
notifying you of the end of communications appears.
9 Press [MENU] to exit.
CONFIGURING AN IDENTIFICATION LETTER FOR THE
SECONDARY CLOCK
You can configure an alphabetical letter for the
identification letter of the Secondary Clock.
1 Press [CLOCK] (F) from the Menu screen to open the
Clock screen.
2 Access Menu 00, "Date and Time".
3 Press [SELECT] (F4).
4 Access Menu 04, "Secondary Clock Identification
Letter".
5 Press [SELECT] (F4) to allow editing of the parameter
box.
6 Press [-] (F2) or [+] (F3), or rotate the MULTI/CH
control to select the identification letter.
The default is "U" which is an abbreviation for UTC
(Universal Time Coordinated).
7 Press [ ] (F1).
8 Press [MENU] to exit.

CONFIGURING THE DATE DISPLAY FORMAT

The date display format can be configured.
1 Press [CLOCK] (F) from the Menu screen to open the
Clock screen.
2 Access Menu 00, "Date and Time".
3 Press [SELECT] (F4).
4 Access Menu 05, "Date Display Format".
5 Press [SELECT] (F4) to allow editing of the parameter
box.
Index Contents