Configuring The Output To An External Meter - Kenwood TS-990S Instruction Manual

CONFIGURING THE OUTPUT TO AN EXTERNAL
METER
Connecting an analog meter (commercially available) to
the METER connector on the rear panel enables you to
display the levels of signals transmitted or received on the
main band and the sub band. The signal type to the main
band and the sub band can be configured independently.
Follow the procedure below to select the type of signal
to be transferred to an external meter while transmitting.
Signal strength is the signal type to be transferred to an
external meter while transmitting.
The METER terminal has the following output
rating. {page 2-10}
Voltage 0 V to 5 V (no load)
Input Impedance: 4.7kΩ
SELECTING THE OUTPUT SIGNAL TYPE OF THE MAIN
BAND FOR AN EXTERNAL METER
You can configure the signal type of the main band to be
transferred to an external meter from the METER terminal.
F[ADV]
[F1] [F7]
1 Press [ADV] (F) from the Menu screen to open the
Advanced Menu screen.
2 Access Advanced Menu 00, "Indication Signal Type
(Main Band)" 'External Meter 1).
3 Press [SELECT] (F4) to allow editing of the parameter
box.
Contents Index
4 Press [-] (F4) or [+] (F5), or rotate the MULTI/CH
control to select the signal format.
The following signal types are used. The default is
"Automatic".
Automatic
The S-meter level while receiving or a value or the signal level
displayed in the key guide [METER] (F) can be transferred from the
METER terminal. In any case, the temperature status detected from
the protective circuit of the transceiver cannot be transferred.
TX Power
The transmit power level can be transferred.
ALC
The signal level for the ALC circuit can be transferred.
Vd (Drain Voltage)
The drain voltage value of the power amplification (FET) element can
be transferred.
COMP (Compression Level)
Displays the level of the audio signal emphasis by a speech
processor.
ID (Current)
The drain current of the power amplification (FET) element can be
transferred.
SWL
The SWR can be transferred.
5 Press [
6 Press [MENU] to exit.
[MENU]
USEFUL FUNCTIONS 16
] (F1).
16-15