SWITCHING THE COM CONNECTOR PIN
ARRANGEMENT
You can configure the RTS/CTS terminals of the COM
connector on the rear panel allowing it to function in the
same manner as the MSQ/PKS terminals of the ACC 2
connector.
[
]
F[ADV]
[F1] [F7]
1 Press [ADV.] (F) from the Menu screen to open the
Advanced Menu screen.
2 Access Menu 24, "MSQ/PKS Pin Assignment (COM
Connector)".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "On" or "Off" to
determine the pin behavior.
The default is "Off".
Off: The COM connector is normal (CTS/RTS mode).
The COM connector processes the RTS signal and CTS
signal.
On: The COM connector is in MSQ/PKS mode.
The signal on the RTS and CTS pins of the COM connector
are replaced with the MSQ and PKS signals, respectively.
A message confirming the COM connector behavior appears.
5 Press [OK] (F4).
6 Press [
] (F1).
7 Press [MENU] to exit.
8 Press [ ] to turn the transceiver power ( ) OFF, press
[ ] again to turn the transceiver power ( ) ON.
Contents
Index
The output signals for each configuration behaves as
follows:
CTS/ RTS
(Default)
[MENU]
MSQ/ PKS
Note:
◆ The revised configurations cannot be enabled until the transceiver
is restarted.
◆ If "On" is configured for the MSQ/PKS Pin Assignment, you cannot
control the transceiver using the ARCP-990 and ARHP-990 or by
PC commands sent via the COM connector.
◆ If "Off" is configured for the MSQ/PKS Pin Assignment, the
transceiver transmits when the PKS pin of the ACC 2 connector is
shorted to GND.
◆ The I/O level of the audio varies depending on the sound device
connected. If the audio I/O level does not match the transceiver,
use Menus 7-06, 7-10, and 7-11 to change the audio I/O level on
the ACC 2 connector.
◆ The squelch signal of the sub band cannot be transferred.
USEFUL FUNCTIONS 16
COM Terminal on the
rear panel
TxD
→
RxD
←
RTS
→
CTS
←
GND
No function
→
No function
←
MSQ
→
PKS
←
GND
{page 16-20}
PC
RxD
TxD
CTS
RTS
GND
RxD
TxD
CTS
RTS
GND
16-25