Kenwood TS-990S Instruction Manual page 179

target frequency to be adjusted.
6 Press [-] (F5) or [+] (F6), or rotate the MULTI/CH
control to select the level for each frequency band.
Press and hold [(RESET)] (F2) to revert all frequency levels
to their defaults.
7 Press [ESC], or press and hold [TXEQ/SEL] to exit.
Press [ ] (F1) to revert to the TX Equalizer screen.
Note:
◆ The configurations for other frequency characteristics than User 1
to User 3
COPYING THE CONFIGURATION DATA FOR THE TX
DSP EQUALIZER
After adjust the TX Equalizer according to your preference,
you can copy and save the configuration data as the user.
1 Press and hold [TXEQ/SEL] to open the TX Equalizer
screen.
2 Press [ ] (F2) or [
MULTI/CH control to select the desired characteristics
of the speech processor.
3 Press [COPY] (F5) to copy the configuration data.
A message notifying you about how to specify the destination of
the copied configuration data appears.
4 Press [USER1] (F2), [USER2] (F3), or [USER3] (F4)
to specify the target to copy the configuration data.
• The data copying the configurations for TX DSP equalizer
is complete and the TX Equalizer screen reappears.
• Pressing [CANCEL] (F7) reverts to the TX Equalizer
screen without reading the configuration data.
Contents Index
In the following procedure, you can edit and copy the
configuration data for TX DSP equalizer.
1 Press and hold [TXEQ/SEL] to open the TX Equalizer
2 Press [
3 Press [ADJ] (F4) to open the TX Equalizer screen.
4 Press [COPY] (F7) to start a copy.
5 Press [USER1] (F2), [USER2] (F3), or [USER3] (F4)
SAVING THE CONFIGURATION DATA FOR THE TX DSP
EQUALIZER
You can write the configuration data for the TX DSP
equalizer onto a USB flash drive.
] (F3), or rotate the
[USB]
1 Press and hold [TXEQ/SEL] to open the TX Equalizer
2 Insert a USB flash drive, which has been formatted by
3 Press [
4 Press [SAVE] (F7) to save the configuration data.
screen.
] (F2) or [
MULTI/CH control to select the desired characteristics
of the speech processor.
For the adjustment of the TX DSP equalizer, refer to
"ADJUSTING THE TX DSP EQUALIZER".
A message prompting you to ensure the destination of the
copy appears.
to specify the target to copy the configuration data.
• The data copying the configurations for TX DSP equalizer
is complete and the TX Equalizer screen reappears.
• Pressing [CANCEL] (F7) returns you to the TX Equalizer
screen without copying the configuration data.
REV
[F1] [F7]
[ESC]
screen.
the transceiver, into the
After the USB flash drive has been correctly recognized,
" " appears on the main screen.
] (F2) or [
MULTI/CH control to select the desired characteristics
of the speech processor.
TRANSMIT FUNCTIONS 9
] (F3), or rotate the
{page 9-10}
[MULTI/CH]
[TXEQ/SEL]
(USB-A) connector.
] (F3), or rotate the
9-11