Adjusting The Anti Vox Gain Level - Kenwood TS-990S Instruction Manual

9 TRANSMIT FUNCTIONS
4 While you are speaking into the microphone, press
[-] (F6) or [+] (F7), or rotate the MULTI/CH control to
adjust the VOX Delay Time.
Adjusts the VOX delay time for when to revert to the receive
state after you stop speaking.
Available Range is "Off" or from "1" to "20" (in steps of 1). The
default is "10".
5 Press [ESC], or press and hold [VOX/SEL] to exit.
Note:
◆ Even if the audio source is configured for Data VOX in the
Modulation Source screen, the same delay time adjusted for the
VOX delay time will be applied to the Data VOX delay time.
◆ The configurations described above does not apply to Data VOX.
■ Data VOX
1 Press and hold [VOX/SEL] to open the VOX screen.
In the VOX screen, a line highlights the selected audio
source, and a row highlights the selected configuration item.
2 Press [ ] (F2) or [
row for the audio source.
You can select from "ACC 2", "USB" and "Optical" row for the
audio line to be adjusted.
3 Press [ ] (F4) or [
for "VOX DELAY".
4 Press [-] (F6) or [+] (F7), or rotate the MULTI/CH
control to select the delay time.
• Sourcing the audio signal from the audio source selected in
step 2, you can adjust the delay time to revert to the receive
state after finishing the entry of audio signal.
• Available range is "0" to "20" (in steps of 1). The default is
"10".
5 Press [ESC], or press and hold [VOX/SEL] to exit.
9-4
] (F3) to select the
] (F5) to select the line

ADJUSTING THE ANTI VOX GAIN LEVEL

While VOX is active, sound from not only the microphone
but also from the speaker may cause VOX to start
transmitting. The transceiver will transmit if the speaker
volume is set too high. Adjust the anti-VOX level based
on the sound from the speaker and set a lower limit of
audio to activate the VOX function to avoid accidental
transmission.
Operations for the VOX function (Voice) and Data VOX are
identical.
[ESC] [VOX/SEL] [F1] [F7]
[VOX GAIN]
1 Press and hold [VOX/SEL] to open the VOX screen.
In the VOX screen, a line highlights the selected audio
source, and a row highlights the selected configuration item.
2 Press [ ] (F2) or [
row for the audio source.
3 [ ] (F4) or [
ANTI VOX.
The parameter box becomes active, and the parameter can
be changed.
4 Press [-] (F6) or [+] (F7), or rotate the MULTI/CH
control to adjust the sensitivity of the Anti VOX Gain.
• Adjust the sensitivity of the anti-VOX level so that the sound
from the speaker does not result in transmitting.
• Available range is "0" to "20" (in steps of 1). A smaller value
will be more susceptible to the sound of the speaker.
• The following table shows the default settings.
• MICROPHONE (MIC): 10
• ACC 2: 0
• USB: 0
• OPTICAL: 0
5 Press [ESC], or press and hold [VOX/SEL] to exit.
Note:
◆ If a set of headphones is connected to the PHONES connector, the
sound from a speaker does not activate the VOX function to transmit
regardless of configurations for the audio line and Anti VOX Level.
◆ Anti VOX Gain for the audio sources other than Data VOX can be
adjusted. {page 9-4}
[MULTI/CH]
] (F3) to select the
] (F5) to highlight a column for
Index Contents