Kenwood TS-990S Instruction Manual page 283

SYMPTOMS ENCOUNTERED DURING RECORDING AND PLAYING
Symptom
The message appears when [
during the timer recording.
As a result of the timer recording, no sound is
audible from the recorded file.
Voice message cannot be recorded.
The repeat interval of the voice message
does not function.
The received audio can be recorded only for
30 seconds.
WAV file cannot be played.
Audio file cannot be deleted.
The volume to play (reception) is small.
The volume to play (transmission) is small.
No signal is entered from the OPTICAL IN
connector.
No signal is entered from the OPTICAL OUT
connector.
Contents Index
Common Problem
Timer recording is in process.
] is pressed
Mute was active during the timer recording.
The audio source is not configured as desired. Be sure that the audio source is correct
You attempt to use the repeat interval only for
playing of the voice message.
Repeating is disabled.
The received audio is recorded to the internal
memory.
Full time recording is selected.
The audio file has different file format than what
the transceiver can play.
The file is the delete protected.
Rotate the AF (M) control counterclockwise.
Rotate the AF (S) control counterclockwise.
The sampling rate of the transceiver does not
march the sampling rate of the sourcing device.
The sampling rate of the transceiver does not
march the sampling rate of the target device.
TROUBLESHOOTING 18
What to do
Press and hold [(BREAK)] (F4) to
abort the timer recording and allow the
transceiver to be operable. To continue
the timer recording, press [ ].
Be sure that the mute is inactive during
the timer recording. While the muting
capability is active, the received audio
cannot be recorded.
and the input signal level is appropriate.
The repeat interval can function only
when the voice message is played
during the transmission. This does not
function only for playing.
Enable the repeating for the channel
you wish to repeat.
Use the USB flash drive to store the
received audio.
The maximum recording time for the
Full time recording is 30 seconds
despite of the destination.
The transceiver can play the audio file
with the following format.
Number of channels: 2, Number of bit:
16, sampling frequency: 16 kHz
Cancel the delete protection.
Rotate the [AF] (M) control clockwise
to adjust.
Rotate the [AF] (S) control clockwise
to adjust.
The sampling frequency for the entered
signal is 44.1 kHz and 48 kHz, the
number of bit is 24 or 16.
The sampling frequency for the signal
to be transferred is 48 kHz, the number
of bit is 24.
Ref. Page
{page 15-5}
{page 4-7}
{page 13-1}
{page 13-3}
{page 13-3}
{page 12-1}
{page 13-5}
{page 13-10}
{page 4-7}
{page 4-7}
{page 2-9}
{page 2-9}
18-13