Deleting A File From Usb Flash Drive - Kenwood TS-990S Instruction Manual

Prepare a USB flash drive where the target files are
stored, and then follow the procedure below.
1 Insert a USB flash drive to the
" " blinks on the main screen, and "
transceiver recognizes the USB flash drive.
2 Press [USB DRIVE] (F) on the Menu screen to open
the USB screen.
3 Select Menu "Read Configuration Data".
4 Press [SELECT] (F4) to open the File (Configuration
Data) screen.
• File names stored in a USB flash drive appear.
• Pressing [CANCEL] (F7) aborts the procedure without
reading the data.
5 Press [ ] (F2) or [
MULTI/CH control to select the desired file.
6 Press [OK] to open the Read Data Option screen.
Pressing [CANCEL] (F7) aborts the procedure without
reading the data.
7 Press [ ] (F2) or [
MULTI/CH control to select the configuration data to
be read.
8 Press [ ] to place a tick mark on the left side
of the configuration data name.
Each key press places a tick mark (reading the configuration
data) or removes the tick mark (not reading the configuration
data).
9 Repeat steps 7 and 8 to configure whether or not each
configuration data will be read.
10 Press [OK] (F4) to start reading of the file.
Upon completion of the reading, a message notifying you the
end of configuration data reading appears.
11 Press [OK] (F4) to exit.
The transceiver automatically restarts.
Contents Index
(USB-A) connector.
" lights when the
] (F3), or rotate the
] (F3), or rotate the
PRECAUTION:
◆ Do not remove the USB flash drive while the configuration data file
or the audio data file is being read from the USB flash drive. Also,
do not shut down the main power switch (I/O). Otherwise, failure in
the safe removal of the USB flash drive may cause damage to the
USB flash drive, the configuration data file, the audio data file and
the malfunction of the transceiver.

DELETING A FILE FROM USB FLASH DRIVE

The configuration data file and the audio data file stored in
a USB flash drive can be deleted from the USB flash drive.
F[USB DRIVE]
[USB] [ESC] [F1] [F7]
Prepare a USB flash drive where the target files are
stored, and then follow the procedure below to delete a
file.
1 Insert a USB flash drive to the
" " blinks on the main screen, and "
transceiver recognizes the USB flash drive.
2 Press [USB DRIVE] (F) on the Menu screen to open
the USB screen.
3 Access Menu "Read Configuration Data".
4 Press [SELECT] (F4) to open the File (Configuration
Data) screen.
• File names stored in a USB flash drive appear.
• Pressing [CANCEL] (F7) aborts the procedure without
deleting the file.
5 Press [ ] (F2) or [
MULTI/CH control to select the desired file.
6 Press [DELETE] (F6) to delete a file.
A message prompting you to delete a file appears.
7 Press [OK] (F4) to exit.
Pressing [CANCEL] (F7) aborts the procedure without
deleting the file.
ABOUT THE USB FLASH DRIVE 12
[MULTI/CH]
[MENU]
(USB-A) connector.
" lights when the
] (F3), or rotate the
12-3