Restore The Factory Default Settings - CyberData 011111 series Operation Manual

Voip indoor intercom ral 9003, signal white color

Hide thumbs Also See for 011111 series:

Table of Contents

2.2.8 Restore the Factory Default Settings

When troubleshooting configuration problems, it is sometimes convenient to restore the device to a

known state. To restore the factory default settings on your device, do one of the following:

• If you have an Intercom that has an RTFM Switch, then see

RTFM

• If you have an Intercom that has a jumper and does not have an RTFM switch, then see

2.2.8.2, "Intercom with a

Note

2.2.8.1 Intercom with an RTFM Switch

Complete the following steps to restore defaults on an Intercom that has an RTFM switch:

1. Press and hold the RTFM switch

Operations Guide

Switch".

Jumper".

Each Intercom is delivered with factory set default values.

The speaker will use DHCP to obtain the new IP address (DHCP-assigned address or

default to 10.10.10.10 if a DHCP server is not present).

930260L

(Figure

2-15) until the Intercom announces the IP address.

Figure 2-15. RTFM Switch

Installing the VoIP Indoor Intercom

Section 2.2.8.1, "Intercom with an

CyberData Corporation

Parts List

Section

Table of Contents

Do you have a question about the 011111 series and is the answer not in the manual?