Table of Contents
Advertisement
When a headset (only with the OpenPhone 27) is connected, calls are established
automatically, and you can telephone without your hands. When the caller goes
on-hook (i.e. puts the phone down), the call is disconnected. If you are not using
the headset, then please deactivate this function as unnoticed listening-in by a
caller is possible.
Note
The "Automatic call answer" function should only be used when the "Silent charging"
function, described below, is off.
•
Silent charg. (OpenPhone 26) / Silent Charging (OpenPhone 27): The handset
does not signal any calls as long as it is in the charger. This applies to acoustic sig-
nalling via the ringer, to visual signalling and for signalling by the vibration alarm.
As soon as you remove the handset from the charger, calls are signalled again. Use
the OK softkey to activate (") or deactivate the function.
•
Coverage Warn.: This menu entry is only displayed with an OpenPhone 27. The
coverage warning sounds a warning tone when leaving the radio range. Use OK to
activate (") or deactivate this function.
•
Username (OpenPhone 26) / User Name (OpenPhone 27): Here you enter or edit
the name that appears on the display when the handset is in the idle state. Use the
OK softkey to save the setting.
Note
The user name saved here is a two-character abbreviation displayed on this phone
only. It is not identical to the user name the administrator enters for a user when con-
figuring the OpenCom 100 / Aastra 800 and which is used in the central phone book,
for example.
Language: Select a language from the list and confirm with OK. Display texts then
•
appear in this language.
•
Display Contrast (OpenPhone 26) / Contrast (OpenPhone 27): Use the arrow keys
to adjust the display contrast and confirm with OK.
•
Default setting: Use this function to reset your handset to the factory settings.
This menu is only displayed with an OpenPhone 26.
Features and Menus
81
Advertisement
Table of Contents
