Table of Contents
Advertisement
– New: You subscribe the handset (PP = Portable Part) to the base station (FP =
Fixed Part). Possibly you will need the PARK of the base station. If you wish to check
in the handset using the secured procedure, you will need the FP PIN of the base
station (also referred to as AC = Authentication Code). If you are using the sim-
plified procedure, leave this field blank. For more information on checking in
handsets, refer to the OpenCom 100 / Aastra 800 online help.
Enter the PARK and press Go on. Enter the Auth. code (Authentication Code) and
press OK. After a successful check in, you can enter the name and number for the
subscription entry. Confirm with OK.
– Edit: You can edit the name and display of the call number (usually the internal/
local call number) for the selected subscription record. This information appears in
the idle state when the handset is registered on the corresponding base station.
Note
With the OpenCom 100 / Aastra 800, you do not need to enter an internal call
number for the handset since the communications system manages internal call
numbers automatically.
– Delete: Here you delete the subscription record of the base station in your
handset. The handset can only be operated on this system when it has been
checked in again. When the last entry in this list has been deleted, the handset
automatically begins to search for a new base station to subscribe to.
– Delete All: Here you delete all subscriptions.
Telephone options: This menu contains further terminal-specific settings.
Auto-Keylock (OpenPhone 26) / Auto Key Lock (OpenPhone 27): Use OK to
•
activate (") or deactivate automatic keypad lock. When the automatic keypad lock
is active, the keypad lock is automatically switched on if you do not use the device
for more than 60 seconds in the idle state.
•
Key Click: This menu entry is only displayed with an OpenPhone 27. For each key
operation a short signal tone can be activated. With OK you activate (") or deac-
tivate the key click.
•
Alarm: This menu entry is only displayed with an OpenPhone 27. You can set a
time between 00:00 and 23:59 at which time the handset will emit an acoustic
signal. The signal type is defined by the ringer tone setting for external calls. The
alarm signal lasts approximately one minute and can be switched off by pressing
Features and Menus
79
Advertisement
Table of Contents
