Table of Contents
Advertisement
Features and Menus
Melody: You can use different melodies to distinguish between four types of
incoming calls: internal calls, external calls, messages and VIP calls. Select the type
of call (Internal, External, Messages, VIP). Then select a melody by using the
arrow keys or entering a digit from 1 to 9.
Info tones: Using the OK softkey you deactivate an info tone or activate it again (").
•
The following info tones are available:
Key click: Every key press results in a click.
Confirm. tones: Every time a handset setting is switched on or off you will hear a
confirmation tone.
Low battery: Three minutes before the phone is switched off due to an empty
battery, you will hear four signal tones.
Coverage warn.: You hear a warning tone when you leave the radio range of the
base station your telephone is currently registered on.
Ringer Settings: In this menu you configure volume and ringing signals for your tele-
phone. This menu is only displayed with an OpenPhone 26.
•
Melody: You can use different melodies to distinguish between four types of
incoming calls: internal calls, external calls, messages and VIP calls. Select the type
of call (Internal, External, Messages, VIP). You can select from 30 different mel-
odies.
Then select the melody. Enter 1 ... 9 or in quick succession two digits 10 ... 30 or
modify the displayed number with the arrow keys.
•
Type: As well as a melody, you can assign a different kind of signalling to every call:
The active setting is displayed with ". Select the desired setting and confirm with
OK.
– Full Melody: Ringer signalling with a complete melody
– Single: As ringer signalling the set melody will only be played once.
– Chirp: Short melody, is also only signalled once
•
Device: You can select the combination of signal generators with which the call
will be signalled. An active signal generator is marked with ". Select the desired
signal generator and switch it on or off with OK.
– Buzzer: Activate or deactivate the acoustic ringer tone. If you deactivate the
signal generator then this is shown in the display with the
– Vibrator: Activate or deactivate the vibration signal generator.
76
symbol.
Advertisement
Table of Contents
