Equipments - Mitsubishi Lancer Evolution-VII Workshop Manual

HOW TO READ THE WIRING DIAGRAMS -
Indicates input/output to/from
control unit (current flow direction).
Input/
Input
Output
output
Indicates a wiring connector which is inside
the equipment and which is not shown in
the wiring harness configuration diagram.
Indicates a connector
Example C-15-2
which is inside the
equipment, numbered
in order starting from 1.
Indicates theconnectornumber
shown in the wiring harness
configuration diagram.
Indicates that the terminal is a spare
one if the device (sensors in this
case) is not provided.
How to Read Circuit Diagrams
A broken line indicates that these
connectors are the same intermedi-
ate connectors.
Indicates that the diagram comes from
which belongs to the
A
in the same circuit.
Indicates terminal No.
In case two or more connectors are
connected to the same device, markings
indicating the same connectors are
connected by a broken line.
Indicates current flow downward or
upward as controlled by the control unit.
Indicates harness junction where wire
diameter or colour changes.
Indicates intersections at
which the lead wire are not
connected.
Indicates intersections at
which the lead wires are
connected.
Indicates representative vehicle body
earth point. (Same No. as that of earth
point in wiring harness diagram and
installation locations of individual parts.)
A-5
1 block