Camshaft And Camshaft Oil Seal - Mitsubishi Lancer Evolution-VII Workshop Manual

11A-16
ENGINE -
Hole A
L-shaped
hexagon
wrench

CAMSHAFT AND CAMSHAFT OIL SEAL

REMOVAL AND INSTALLATION
Caution
If the vehicle is equipped with the Brembo disc brake, during maintenance, take care not to contact
the parts or tools to the caliper because the paint of caliper will be scratched.
Pre-removal and Post-installation Operation
Under Cover Removal and Installation (Refer to GROUP 51 - Front Bumper.)
D
Drive Belt Tension Check (Refer to P.11A-7.) <After installation only>
D
Drainage and Refilling of Engine Coolant (Refer to GROUP 14 - On-vehicle Service.)
D
Air Duct Removal and Installation (Refer to Group 15 - Air Cleaner.)
D
Air Pipe C Removal and Installation (Refer to GROUP 15 - Intercooler.)
D
Secondary Air Pipe Assembly Removal and Installation (Refer to GROUP 15 - Secondary Air Supply System.)
D
Timing belt Removal and Installation (Refer to P.11A-34.)
D
Crankshaft Pulley/Camshaft and Camshaft Oil Seal
REMOVAL SERVICE POINT
AA" DRIVE BELT REMOVAL
Due to the adoption of the Serpentine drive system with the
auto-tensioner, the following operation is required:
1. Insert the 12.7sq. spinner handle and etc. into the tool
hole of the auto-tensioner and rotate it counterclockwise
until the auto-tensioner gets to the stopper.
2. Align hole A with hole B for fixing by inserting the L-shaped
hexagon wrench, then remove the drive belt.
Hole B
Caution
When the drive belt is reused, use a chalk to indicate
an arrow of rotation direction on the back of the belt
so that it can be re-assembled in the same direction
as before.