Mitsubishi Lancer Evolution-VII Workshop Manual page 259

HOW TO READ THE WIRING DIAGRAMS -
HOW TO READ CONFIGURATION DIAGRAMS
The wiring harness diagrams clearly show the connector locations and harness routings at each site
on actual vehicles.
Denotes connector No.
The same connector No. is used throughout the circuit diagrams to facilitate
connector location searches.
The first alphabetical symbol indicates the location site of the connector
and a number that follows is the unique number. Numbers are assigned to
parts in clockwise order on the diagram.
Example: A-12
Denotes earth point.
Same earth number is used throughout circuit
diagrams to facilitate search of earth point. Refer
to SINGLE PART INSTALLATION POSITION -
EARTH MOUNTING LOCATIONS for details of
earth points.
Denotes a section covered by a
corrugated tube.
The mark L shows the
standard mounting posi-
tion of wiring harness.
Denotes the colour of corrugated
tube or vinyl tube. (If not specified,
it is black.)
R: Red
Y: Yellow
The number of connector pins and the
connector colour (except milk white)* are
shown for ease of retrieval.
Example: (2-B)
Connector colour
(milk white if no colour is indicated)
Number of connector pins
*: Typical connector colours
B: Black
Y: Yellow
L: Blue
G: Green
R: Red
Number specific to connector (serial number)
Connector location site symbol
A: Engine compartment
B: Engine and transmission
assembly
C: Dash panel
BR: Brown
V: Violet
O: Orange
GR: Gray
None: Milk white
How to Read Configuration Diagrams
D: Floor and roof
E: Door
F: Luggage compartment
A-45
A-44
A-43
A-42
R
A-39 (2-B)
A-40 (1)
A-41 (1)
A-42 (2-B)
Indicates the device to which the
connector is to be connected.
A-39
Headlamp (LO: RH)
Horn (LO)
Horn (HI)
Windshield washer motor
A-3