CyberData 011307 Operation Manual page 38

Web Page Item
Misc Settings
Device Name
Auto-Answer Incoming Calls
Button Lit When Idle
Button Brightness (0-255)
Play Ringback Tone
Disable HTTPS (NOT recommended)
Note
Operations Guide
Table 2-7. Device Configuration Parameters (continued)
You can change the SIP
Microphone Gain without rebooting the device. You must save and reboot the device for
other changes to take effect.
930935B
Installing the VoIP Indoor Intercom with Keypad
Description
Type the device name. Enter up to 25 characters.
When selected, the device will automatically answer incoming calls.
When Auto-Answer Incoming Calls is disabled, the device will play a
ring tone (corresponds to Ring Tone on the Audiofiles page) out of
the speaker until someone presses the Call button to answer the call
or the caller disconnects before the call can be answered.
When selected, the Call button LED is illuminated while the device is
idle (a call is not in progress).
The desired Call button LED brightness level. Acceptable values are
0-255, where 0 is the dimmest and 255 is the brightest. Enter up to
three digits.
When selected, the device will play a ringback tone (corresponds to
Ringback Tone on the Audiofiles page) out of the speaker while
placing an outbound call. The Ringback Tone will play until the call is
answered.
Disables the encrypted connection to the webpage. We do not
recommend disabling HTTPS for security reasons.
Click on the Test Audio button to do an audio test. When the Test
Audio button is pressed, you will hear a voice message for testing
the device audio quality and volume.
Click on the Test Microphone button to do a microphone test. When
the Test Microphone button is pressed, the following occurs:
1. The device will immediately start recording 3 seconds of audio.
2. The device will beep (indicating the end of recording).
3. The device will play back the recorded audio.
Click on the Test Relay button to do a relay test.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
Click on the Toggle Help button to see a short description of some of
the web page items. First click on the Toggle Help button, and you
will see a question mark (
items. Move the mouse pointer to hover over a question mark to see
a short description of a specific web page item.
Volume, Multicast Volume,
) appear next to some of the web page
Ring Volume, Sensor
CyberData Corporation
30
Intercom Setup
Volume, and