Receiving Using The Scanning Feature - JRC JHS-32B Instruction Manual

4.2.5
In scanning mode, the unit searches automatically for receivable signals. The three scanning modes
are described below.
• ALL CH SCAN
• MEMORY CH SCAN : Scans all channels (up to 10) that are saved as memory channels.
• SELECT CH SCAN : Scans all channels in the selected range.
OPERATION
Press
MASTER appears for OPE in the CH16 Status
Display.
TIP
• When no remote controller is connected,
pressing
MASTER automatically appears for OPE.
• A controller which does not have priority can be
used only when no other controller is in use
[OPE: OFF], by just pressing the
When using the controller which has priority,
pick up the handset or press
call.
Press
The SCAN Display appears.
Select a scanning mode using
The selected scanning mode is highlighted.
60
4.2 Communicating Using a Specified Channel

Receiving Using the Scanning Feature

: Scans all channels in the selected region.
.
OPE
is not necessary because
OPE
OPE
OPE
.
SCAN
/
.
ITU ITU
MODE: SIMP TEL MODE: SIMP TEL
OPE : MASTER OPE : MASTER
SCAN: OFF
SCAN: OFF
SP SP : ON : ON
21 21 JUL JUL
S: 12°34'
key.
to make a
--SCAN--
1.ALL CH SCAN
2.MEMORY CH SCAN
3.SELECT CH SCAN
SELECT WITH
PRESS STOP
--SCAN--
1.ALL CH SCAN
2.MEMORY CH SCAN
3.SELECT CH SCAN
INPUT CH NO., & PRESS
PRESS CLR
PRESS STOP
16
16
CH CH
OUTPUT: 25W OUTPUT: 25W
ALARM : ENABLE ALARM : ENABLE
SQL : CLOSE
SQL : CLOSE
POWER : AC POWER : AC
1994 1994 14:59 14:59 UTC UTC
U U
W: 123°45'
CH16 25W
ITU CH
FORM CH TO CH
, & PRESS ENTER .
TO RETURN.
CH16 25W
ITU CH
FORM CH01 TO CH88
ENTER .
TO CORRECT.
TO RETURN.