JRC JHS-32B Instruction Manual page 145

FEED
Switch
G When paper runs out.
When about 50cm of printer paper remains, red lines appear on both sides of the paper warning that
paper supply is low. The buzzer sounds a warning when only a very small amount (about 10 cm) of
paper remains. When this happens, follow the procedure below.
TIP First open the paper cover to check that the paper needs to be replaced.
Press
ALM OFF
alarm.
Gently pull out the end of the
paper, holding down
until all paper is removed.
Holder
Paper Cover
to stop the
RESET
Place the center shaft on the
holder and press
FEED
leading edge of the paper appears
at the cutter.
Close the paper cover by pressing
the top until it locks in position.
Press to turn the
POWER
power off.
Open the paper cover, re-
move the center shaft, then
remove the roll core from the
shaft.
Refer to step 3 and " G
Paper" for further information about
loading paper.
until the
Loading Printer
9.3 NKG-52 Printer
1
2
3
4
5
6
7
8
9
10
137