Do not use this equipment for anything other than specified.
Doing so may cause failure or malfunction.
Do not turn the trimmer resistors or the trimmer capacitors on the PCB unit,
except when and if they need to be adjusted. Doing so may cause failure or
malfunction. They are preset at the factory.
Do not install this equipment in a place near water or in one with excessive
humidity, steam, dust or soot. Doing so may cause fire, electric shock, or
Do not insert anything flammable into the cable guide. Doing so may cause fire,
electric shock or unit malfunction.
Do not get this equipment wet or spill any liquids on or near this equipment.
Doing so may cause electrical shock or malfunction.
Do not place this equipment anywhere vibration or impact is likely to occur.
Doing so may cause a fall resulting in injury or damage to property.
Leave installation of this equipment to our service center or agents.
Installation by an unauthorized person may result in malfunction.
The ID number, position data and UTC data described in this instruction manual
are an example. Input correct ID number, position data and UTC data for actual