Printer (Nkg-52) Maintenance And Inspection - JRC JHS-32B Instruction Manual

5.1.5
Inspection sequence
1
2
3
4
5
6
TIP
• *1 Perform the print test using the main unit
(JHS-32B).
• *2 When an alarm sounds, replace the printer
paper. Replacing the paper will not stop the
alarm.
• *3 Be sure to perform this test only after item 4.
This test can not be performed under any other
conditions.
120
5.1 Maintenance and Inspection

Printer (NKG-52) Maintenance and Inspection

Inspected item
Printer control system
Print out test (see *1)
switch
FEED
Alarm operation
switch (see *2)
ALM OFF
switch
RESET
(cancellation of error state)
(see *3)
Procedure
Check the printer cable connection.
Perform a print out test using the JHS-32B.
Press and check that paper advances by one
FEED
line.
Open the paper cover, remove the paper roll from
the holders, then press
FEED
buzzer sounds (because the printer is now out of
paper).
If the buzzer sounded in item 4, press the
switch to stop the alarm.
After stopping the alarm (item 5), press the
switch. It should not function (because the printer is
in the error state) . Check that the paper advances by
one line when RESET is pressed. Then press
and check that the paper advances by one line.
. Check that the
ALM OFF
FEED
FEED