Setting Up The Device - Fujitsu ESPRIMO E5635 Operating Manual

Preparing for use

Setting up the device

When installing your device, give consideration to the safety notes in the "Safety" manual.
!
Only install the device in the operating positions for which it is intended.
We recommend that you place your device on a surface with good anti-slip qualities. In
view of the multitude of different finishes and varnishes used on furniture, it is possible that
the rubber / plastic feet will mark the surface they stand on.
Do not expose the device to extreme environmental conditions (see "Technical data").
Protect the device from dust, humidity, and heat.
When installing the workstation, provide sufficient clearance around the device, as
indicated in the "Technical data" chapter to ensure adequate ventilation. In order to avoid
overheating, do not cover the ventilation area of the monitor or the device.
Do not stack several devices on top of each other.
If you place a monitor on the device, it may weigh a maximum of 25 kg. Make sure that
you do not block any ventilation slots on the device.
Depending on the location of your device, bothersome vibrations and noises may occur.
To prevent this, a distance of at least 10 mm should be maintained from other devices on
casing sides without ventilation surfaces.
The device can operate in either a vertical or horizontal position.
The horizontal operating position is only permitted with the rubber/plastic feet (due to heat
!
produced on the underside).
8 A26361-K691-Z220-1-7619, edition 2