Installing And Removing A Board; Installing Board In Low-Profile Slot - Fujitsu ESPRIMO E5635 Operating Manual

Installing and removing a board

!
Please take note of the section "Information about boards".
There is a corresponding rear panel for both low-profile boards and long boards.
The number, position and arrangement of the board slots on the mainboard can be found in the
manual for the mainboard. Boards may already be installed when the device is shipped.
You can fix boards in two ways:
● with the lock (low-profile boards only)
● with the bracket

Installing board in low-profile slot

► Open the casing (see "Opening the casing").
► Press on the locking lever in the direction of the arrow (1), unhook it and swing it up in the
direction of the arrow (2).
► Remove the rear slot cover plate from the slot (3).
Do not dispose of the cover plate. For cooling, protection against fire and in order to
!
comply with EMC regulations, you must refit the cover plate if you remove the board.
► Make the required settings for the board.
► Push the board up to its slot (4) as far as the stop.
► Press the board into the slot so that it engages.
► Fold the lock closed in the direction of the arrow (5) and allow it to engage.
► If necessary, connect the cables.
► Close the casing (see "Closing the casing").
If you have installed or removed a PCI board, please check the relevant PCI slot settings
i
in the BIOS Setup. If necessary, change the settings. Further information is provided in the
PCI board documentation.
A26361-K691-Z220-1-7619, edition 2
2
1
3
System expansions
5
4
43