No Mouse Pointer Displayed On The Screen; The Floppy Disk Cannot Be Read Or Written; Time And/Or Date Is Not Correct; Error Messages On The Screen - Fujitsu ESPRIMO E5635 Operating Manual

No mouse pointer displayed on the screen

► Shut down the operating system properly.
► Switch off the device.
► Check that the mouse cable is properly connected to the system unit.
If you use an adapter or extension lead with the mouse cable, check the connections.
► Make sure that only one mouse is connected.
► Switch the device on.

The floppy disk cannot be read or written

► Check that the write protection of the floppy disk or the floppy disk drive is activated (refer to
the "BIOS Setup" manual and if necessary to the manual for the mainboard).
► Check the relevant entries for floppy disk drive in the Main menu of the BIOS Setup.
► Check that the floppy disk drive controller is enabled (refer also to the manual for the
mainboard or in the "BIOS Setup" manual).
► Check that the cables of the floppy disk drive are properly connected (see "Replacing the
floppy disk drive").

Time and/or date is not correct

You can set the time and date in the BIOS Setup or in the operating system.
► Set the time and date.
If the time and date are repeatedly wrong when you switch on your PC, the on-board
i
battery is flat. Change the lithium battery as described in the "Extensions to the
mainboard"-"Replacing lithium battery".

Error messages on the screen

Error messages and their explanation are contained:
● in the manual for the mainboard
● in the "BIOS Setup" manual
● in the documentation for the programmes used
A26361-K691-Z220-1-7619, edition 2
Troubleshooting and tips
35