Vertical operating position
Proceed as follows to operate the device in the vertical operating position:
►
If necessary, disconnect the cables.
►
Position the casing vertically so that the ON/OFF switch is located at the bottom.
►
Pull off the foil from the rubber / plastic feet that you will find in the accessories package.
37 mm
1
1
►
Glue the rubber/plastic feet (1) on the casing wall.
In order to ensure that the device is stable, the position of the rubber/plastic feet must
correspond to the given dimensions.
►
Place the unit on the rubber / plastic feet and reconnect any cables disconnected previously.
The set-up direction is specified. The ON/OFF switch must be at the top to ensure
!
sufficient ventilation.
A26361-K691-Z220-1-7619, edition 2
Preparing for use
57 mm
6 mm
1
1
9