Table of Contents
Advertisement
Setting up the device
Videoworkstation
Device,
Ergonomic
You can set up and operate the device in either a vertical or horizontal position.
When installing your device, please read the recommendations and
safety notes in the "Safety" manual.
Use the device simply in the horizontal operating position. With the aid of suitable
feet, it is also possible to use the device in the vertical operating position..
We recommend that you place your device on a surface with good anti-slip qualities.
In view of the multitude of different finishes and varnishes used on furniture, it is
possible that the rubber feet will mark the surface they stand on.
Depending on the location of your device, spurious vibrations and noises may
occur. To prevent this, on casing sides without ventilation surfaces a distance
of at least 10 mm should be maintained from other devices.
To ensure the casing receives adequate ventilation, when setting up the
device make sure that there is sufficient clearance around it as indicated
in the chapter
In order to avoid overheating, do not cover the ventilation areas
of the monitor or the device.
Do not stack several devices on top of each other.
Do not expose the device to extreme ambient conditions (see
Page
53, "Ambient conditions"). Protect the device against dust, humidity and heat.
Vertical operating position (optional)
Use the optional rubber feet when you wish to use the device in
the vertical operating position.
The set-up direction is compulsory: The ON/OFF switch must be at
the top to ensure sufficient ventilation.
Fujitsu Technology Solutions
"Technical specification", Page
53.
"Technical specification",
Getting started
13
Advertisement
Table of Contents
