Log Installation - Rinnai Timberflame IB35 ETR Operating And Installation Instructions

LOG INSTALLATION

T
he logset is packed inside the heater and the packaging must be removed prior to
installing the logset in its correct position.
• Open both side panels.
• Remove fastenings on both sides of the
top glass retainer.
Lift retainer away from heater.
• Loosen screws on bottom glass retainer.
Carefully lift glass out of bottom channel.
• Carefully remove log packaging.
The logset consists of a Main Log which has four pins on the top, for the location of the Top and Right Logs
and two holes underneath for location onto the pins inside the heater.
Place the logset into the heater ensuring that the locating pins enter the two locating holes on the
bottom face of the logset, if not already attached.
vvvvv
Carefully position the Top Log and the Right Log on the locating pins of the Main Log as shown.
Top Log
Main Log
Gently place loose ember bed material in front of the front log. Do not pour as dust particles from
the plastic bag may block the burner ports. Level it with a pencil or screwdriver and remove excess
material. Note: The ember bed material must be placed after the logs are fitted. If the logs are to be removed
for any reason, the ember bed material must be removed first and replaced after the logs are refitted. Any
material that prevents the logs sitting flat on the burner top can upset the burning pattern and performance
of the heater.
• Replace glass and top glass retainer, tighten bottom glass retainer screws.
• Note: Fit glass so that the join/gap in the glass seal is at the bottom.
• Take care not to damage seals.
• Reinstall side panels.
Note: When first lighting the heater, the logs need to be burnt in, which may take approximately 2
hours. The flame colour may change after the initial burning in period.
15
Right Log