Table of Contents
Advertisement
TO OPEN THE CONTROL PANEL
•
Lift lightly in the centre of the lid where there is a catch. The control panel lid will then open backward to
an angle.
TURNING ON
•
Press the ON/OFF button to operate the heater. The ON indicator will glow green. The spark generator will
be heard before the burner ignites and the ON indicator glows red, indicating that the burner is alight.
Warm air can be felt coming from the louvres. The fan will come on automatically after 4 minutes.
If the heater does not ignite on initial use, this may be due to air remaining in the gas supply line. The
spark generator will only continue for 15 seconds. After this it will be necessary to press the ON/OFF
button OFF, then ON again.
TURNING OFF
•
Simply press the ON/OFF button to switch off the heater. The ON indicator will go out. The convection fan will
continue to operate for several minutes after the burner has gone out in order to cool the appliance. Do not
unplug the appliance while the convection fan is running.
DO NOT turn heater off by unplugging at the power point. The convection fan will continue to run
until the appliance cools.
ROOM TEMPERATURE ADJUSTMENT
•
The room temperature and pre-set temperatures can only be displayed and adjusted when the
heater is running.
Press the "
" button to increase the temperature setting or "
The temperatures can be preset to:
If the heater does not ignite then the pre-set temperature may not be set to a setting which is higher
than the room temperature. The ON indicator will change colour from red to green when the heater
reaches the pre-set temperature and stops running.
LOCK
•
The LOCK function will help to prevent accidental operation as well as small children from altering
the controls.
To operate the lock simply press the LOCK button. The function is activated immediately and the LOCK
indicator will glow. To deactivate the LOCK simply press the LOCK button for 3 seconds and the LOCK
indicator will go out. The LOCK can be deactivated at any time in this way.
During normal operation the LOCK may be activated and all controls, other than the OFF switch, will
be locked. Deactivating the LOCK releases the controls. If the LOCK is activated whilst the heater is
turned OFF, then all functions will be locked. If the heater is turned OFF while the LOCK is activated,
it cannot be turned ON again until the LOCK is deactivated.
FLAME
•
To operate the Flame function, simply press the FLAME button. This function will automatically override
the thermostat and set the heater to a default Medium High heat setting for full visual flame effect.
AUTO OFF
•
To operate the Auto Off function, simply press the Auto Off button.
When the Auto Off function is ON, the indicator light will flash and the thermostat will turn the burners
down to the OFF heat setting.
When the Auto Off function is OFF, the indicator light will go Off and the thermostat will turn the burners
down to the LOW heat setting.
OPERATION
a) [L] low (about 10°C)
b) [16°C] to [26°C] in 1°C steps
c) [H] (continuously high)
4
" button to decrease the temperature setting.
Hide quick links:
Advertisement
Table of Contents
