Error Codes - Rinnai Timberflame IB35 ETR Operating And Installation Instructions

ERROR CODE MESSAGE
•
The Flame Fire ETR has the ability to check its own operation continuously. If a fault occurs, an Error
Message will flash on the Digital Display of the control panel. This assists with diagnosing the fault, and may
enable you to overcome a problem without a service call. Please quote the code displayed when enquiring
about service.
Error Code
1 1
1 2
1 4
1 6
3 1
3 2
3 3
7 0
7 1
7 2
7 3
9 9
--:--
In all cases, you may be able to clear the Error Message simply by turning the heater OFF, then ON again. If
the Error Message still remains or returns on the next operation, please contact your nearest service contact
and arrange for a service call.

ERROR CODES

Probable Cause
Ignition Failure
Flame Failure
Overheat
Room Overheat
Room temperature
Sensor Faulty
Room temperature
Sensor Faulty
Overheat temperature
Sensor Faulty
Faulty ON / OFF Switch
Faulty Solenoids
Faulty Flame Rod
Communication error
Flue Block
Power Failure
8
Comments
Check gas is turned on.
Service call if repeated.
Check gas is turned on.
Service call if repeated.
Service call.
Lower room temperature
º
to less than 40 c.
Service call.
Service call.
Service call.
Service call.
Service call.
Service call.
Turn heater OFF,
then ON again.
Service call.
Turn heater OFF,
then ON again.