To Cancel; To Turn Off; To Resume; To Vary The Speed Setting - Dodge DURANGO 2020 Owner's Manual

be defaulted to 20 mph (32 km/h). If the
system is set when the vehicle speed is above
20 mph (32 km/h), the set speed shall be the
current speed of the vehicle.
NOTE:
ACC cannot be set if there is a stationary vehicle
in front of your vehicle in close proximity.
Remove your foot from the accelerator pedal. If
you do not, the vehicle may continue to
accelerate beyond the set speed. If this occurs:
The message "DRIVER OVERRIDE" will

display in the instrument cluster display.
The system will not be controlling the distance

between your vehicle and the vehicle ahead.
The vehicle speed will only be determined by
the position of the accelerator pedal.
T C
O ANCEL
The following conditions cancel the system:
The brake pedal is applied.

The CANC button is pushed.

An Anti-Lock Brake System (ABS) event occurs.

The gear selector is removed from the DRIVE

position.
The Electronic Stability Control/Traction

Control System (ESC/TCS) activates.
The vehicle parking brake is applied.

Driver seat belt is unbuckled at low speeds.

Driver door is opened at low speeds.

The driver switches ESC to Full Off mode.

The braking temperature exceeds normal

range (overheated).
T T O
O URN FF
The system will turn off and clear the set speed
in memory if:
The Adaptive Cruise Control (ACC) on/off

button is pushed.
The Normal (Fixed Speed) Cruise Control on/

off button is pushed.
The ignition is placed in the OFF position.

T R
O ESUME
If there is a set speed in memory push the RES
(resume) button and then remove your foot
from the accelerator pedal. The instrument
cluster display will display the last set speed.
STARTING AND OPERATING
NOTE:
ACC cannot be resumed if there is a stationary
vehicle in-front of your vehicle in close prox-
imity.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to
follow these warnings can result in a collision
and death or serious personal injury.
T V T S S
O ARY HE PEED ETTING
To Increase Speed
While ACC is set, you can increase the set speed
by pushing the SET (+) button.
The driver's preferred units can be selected
through the instrument panel settings. Refer to
"Getting To Know Your Instrument Panel" for
more information. The speed increment shown
is dependent on the chosen speed unit of
U.S. (mph) or Metric (km/h):
205
5