Battery Location; Jump Starting Procedures - Dodge CHARGER Hellcat 2017 User Manual

W H A T T O D O I N E M E R G E N C I E S
(F) Sealant Bottle And Hose Replacement:
1. Uncoil the Sealant Hose (6) (clear in color).
2. Locate the round Sealant Bottle release button in the recessed area under the sealant
bottle.
3. Push the Sealant Bottle release button. The Sealant Bottle (1) will pop up. Remove the
bottle and dispose of it accordingly.
4. Clean any remaining sealant from the Tire Service Kit housing.
5. Position the new Sealant Bottle (1) in the housing so that the Sealant Hose (6) aligns
with the hose slot in the front of the housing. Push the bottle into the housing. An
audible click will be heard indicating the bottle is locked into place.
6. Verify that the cap is installed on the fitting at the end of the Sealant Hose (6) and
return the hose to its storage area (located on the bottom of the air pump).
7. Return the Tire Service Kit to its storage location in the vehicle.

BATTERY LOCATION

The battery is stored under an access cover in the trunk. Remote battery posts are located
on the right side of the engine compartment for jump starting.

JUMP STARTING PROCEDURES

If your vehicle has a discharged battery, it can be jump started using a set of jumper cables
and a battery in another vehicle or by using a portable battery booster pack. Jump starting
can be dangerous if done improperly, so please follow the procedures in this section
carefully.
NOTE:
When using a portable battery booster pack, follow the manufacturer's operating instruc-
tions and precautions.
Do not attempt jump-starting if the battery is frozen. It could rupture or explode and
cause personal injury.
Do not use a portable battery booster pack or any other booster source with a system
voltage greater than 12 Volts or damage to the battery, starter motor, alternator or
electrical system may occur.
WARNING!
CAUTION!
197