Removing The Drv Board - Epson Perfection V700 Photo Service Manual

EPSON Perfection V700 Photo

4.2.14 Removing the DRV Board

1. Move the TPU Carriage Unit to the centre.
See Section 4.2.10 on page 55.
2. Remove the TPU Unit Cable.
3. Remove the two C.B.P. M3 x 8 screws that secure the DRV Board
Cover and remove it.
DRV Board Cover
C.B.P. M3x8
(6±1 kgf.cm)
Positioning Hole and Guide Pin
Figure 4-53. Removing the DRV Board Cover
Disassembly / Assembly
See Section 4.2.11 on page 57.
C.B.P. M3x8
(6±1 kgf.cm)
Disassembly Procedure
4. Disconnect the TPU Motor cable from connector CN3, and the
DRV-SUB_B FFC from CN4 on the DRV Board, and remove the
DRV Board.
TPU Motor
Connector CN3
Positioning Hole and Guide Pin
Figure 4-54. Removing the DRV Board
When installing the DRV Board, match the positioning
holes and the guide pins as shown in
When installing the DRV Board Cover, match the
positioning holes and the guide pins as shown in
4-53.
Revision A
DRV Board
DRV-SUB_B FFC CN4
Figure 4-54.
Figure
61