Removing The Scsi Board - Epson ES-300C User Manual

Removing the SCSI Board

When you need to change the
your dealer, you must remove the SCSI board from the scanner.
1. Turn off the scanner and disconnect the power cable.
2. Remove the three retaining screws from the back panel of the
SCSI board on the back of the scanner. Keep the retaining screws
in a safe place.
3. Pull the board straight out using the remover grips.
CAUTION: Do not pull the board by the connectors or
cables.
Note: If you are taking the SCSI board to your dealer, replace the
slot cover on the back panel of the scanner to keep debris out of
the unit.
Connecting the Scanner to a Macintosh
C-14
ID or take the SCSI board to
SCSI