Epson Perfection V700 Photo Service Manual page 51

EPSON Perfection V700 Photo
9. Remove the CR Drive Belt from the CR Motor Unit following the
procedure below.
1. Release the end A of Torsion Spring 121 from the tab on the CR
Motor Holder, and remove the Torsion Spring 121 from the shaft
of the CR Motor Holder.
2. Remove the C.B. M3 x 3 screws and P.W. M3 x 0.8 screws that
secure the Tension Holder, then remove the Tension Holder and
Pulley.
3. Remove the CR Motor Belt, and then remove the CR Drive Belt.
Tension Holder
CR Motor Belt
CR Drive Belt
Figure 4-28. Removing the CR Drive Belt
Disassembly / Assembly
Pulley
C.B. M3x3 P.W. M3x0.8
(6±1 kgf.cm) (6±1 kgf.cm)
Torsion Spring 121 and shaft
End A and tab
Disassembly Procedure
10. Remove the E-ring that secures the Driven Pulley and remove the
Driven Pulley.
11. Remove the three hex-nuts (H.N.-2, 3), then remove the CR Motor,
and three Motor Insulators.
E-ring
Figure 4-29. Removing the CR Motor
Revision A
Hex-nuts (H.N.-2, 3)
(5.5±0.5 kgf.cm)
CR Motor
Motor Insulator
Driven Pulley
51