Removing The Sub_C Board, Sub_D Board And Lamps - Epson Perfection V700 Photo Service Manual

EPSON Perfection V700 Photo
7. Release the five tabs that secure the Protective Sheet and remove the
TPU Inverter Board.
TPU Inverter Board
Tabs
Figure 4-48. Removing the TPU Inverter Board (2)
Refer to Figure 4-45
Sheet to the TPU Inverter Board.
When installing the SUB_B Board, match the
positioning holes and the guide pins as shown in
4-45.
When installing the LED Cover to the SUB_B Board,
match the positioning holes and the guide pins as
shown in Figure
Disassembly / Assembly
Tabs
Protective Sheet
when attaching the Protective
4-45.
4.2.13 Removing the SUB_C Board, SUB_D Board and
Lamps
1. Remove the TPU Inverter Board.
2. Remove the TPU Lamp Cover using the following procedure.
1. Release all cables from their retaining tabs shown in the figure
below.
2. Remove the two C.B.P. M3 x 6 screws that secure the TPU
Lamp Cover to remove it.
Figure
C.B.P. M3x6
(6±1 kgf.cm)
Positioning Hole
and Guide Pin
Figure 4-49. Removing the TPU Lamp Cover
Disassembly Procedure
See Section 4.2.12 on page 58.
Connector Cables
TPU Lamp Cover
C.B.P. M3x6
(6±1 kgf.cm)
Positioning Hole
and Guide Pin
Revision A
Tabs
59