Epson Perfection V700 Photo Service Manual page 49

EPSON Perfection V700 Photo
6. While lifting the Carriage Unit as shown in
rear of the Carriage Shaft from the notch, and pull the front of the
Shaft out of the bushing in the Base Frame.
7. Pull the Carriage Shaft out of the Carriage Unit.
5-2
Figure 4-25. Removing the Carriage Shaft (3)
Disassembly / Assembly
Figure 4-25, remove the 8. Lift the Carriage Unit, remove the Lock Plate and then remove the
5-3
5-1
9. Disconnect the Carriage FFC CN5 from the Main Board and remove
Disassembly Procedure
CR Drive Belt.
Carriage Unit
Figure 4-26. Removing the CR Drive Belt
the Carriage Unit. See Step 7 in Section 4.2.5
Install the Carriage FFC with reference to
on page 46.
Install the Ground Plate B as shown in
page 48.
Revision A
CR Drive Belt
Lock plate
Figure 4-20
Figure 4-23 on
49