Epson Perfection V700 Photo Service Manual page 46

EPSON Perfection V700 Photo
6. Remove the Ferrite Core from the Lower Main Board Cover.
7. Disconnect the Carriage FFC from CN5 on the Main Board, then
remove the Ferrite Core.
8. Disconnect the Sub Board Connector CN4 from the Main Board.
9. Remove the C.P.F.P. M3 x 8 screw and C.B.P. M3 x 8 screw that
secure the Harness C Cover, and remove the Harness C Cover.
10. Remove the C.P.F.P. M3 x 8 screw that secures the Ground Plate
and remove the Ground Plate.
SUB Board
Harness Cover C
Connector (CN4)
Carriage FFC (CN5)
Ferrite Core
C.P.F.P. M3x8 (7±1 kgf.cm)
C.B.P. M3x8 (7±1 kgf.cm)
Positioning Hole and Guide Pin
Tape Position
Figure 4-20. Removing the Main Board (1)
Disassembly / Assembly
Main Board Ground Plate
Marked Lines
Disassembly Procedure
11. Lift the Main Board and disconnect the CR Motor Relay Connector
CN9, then remove the Main Board.
Main Board
Figure 4-21. Removing the Main Board (2)
Revision A
CR Motor Relay
Connector (CN9)
46