Removing The Tpu Carriage Unit - Epson Perfection V700 Photo Service Manual

EPSON Perfection V700 Photo

4.2.10 Removing the TPU Carriage Unit

1. Remove the TPU Lower Housing.
2. Move the TPU Carriage Unit to the centre.
TPU Carriage Unit
Figure 4-37. Centering the TPU Carriage Unit
Disassembly / Assembly
See Section 4.2.9 on page 54.
Disassembly Procedure
3. Remove the TPU Carriage Shaft according to the following procedure.
1. Remove the TPU Carriage Shaft from the Rear Bushing of the
TPU Upper Housing.
2. Pull the TPU Carriage Shaft out of the Front Bushing of the TPU
Upper Housing.
3. Pull the TPU Carriage Shaft out of the TPU Carriage Unit
toward the rear to remove it.
TPU Carriage Shaft
2
Front Bushing
Figure 4-38. Removing the TPU Carriage Shaft
Revision A
1
Rear Bushing
3
55