Removing The Tpu Unit Cable - Epson Perfection V700 Photo Service Manual

EPSON Perfection V700 Photo

4.2.11 Removing the TPU Unit Cable

1. Remove the TPU Lower Housing.
2. Remove the C.B.P. M3 x 8 screw that secures the grounding wire of
the TPU Unit Cable.
3. Disconnect the TPU Unit Connector CN2 from the DRV Board and
remove the TPU Unit Cable.
C.B.P. M3x8
DRV Board (6±1 kgf.cm)
Figure 4-43. Removing the TPU Unit Cable
Disassembly / Assembly
See Section 4.2.9 on page 54.
TPU Unit Cable
TPU Unit
Connector CN2
Disassembly Procedure
Connect the TPU Unit Cable to the DRV Board following the
procedure given below.
1. Connect the TPU Unit Cable to the DRV Board.
2. While slightly lifting the DRV Board, insert the
grounding wire of the TPU Unit Cable between the
DRV Board and TPU Upper Housing.
3. Secure the grounding wire of the TPU Unit Cable with
the screw together with the DRV Board.
4. Place the TPU Unit Cable onto the notch of the TPU
Upper Housing.
Notch
Figure 4-44. Connecting the TPU Unit Cable
Revision A
DRV Board
Grounding
TPU Unit Cable
57