Removing The Hinges - Epson Perfection V700 Photo Service Manual

EPSON Perfection V700 Photo

4.2.15 Removing the Hinges

1. Remove the TPU Lower Housing.
2. Remove the four C.B.P. M4 x 12 screws that secure the Right and
Left Hinges and remove them.
Right Hinge
Figure 4-55. Removing the Hinges
When installing the Hinges, match the positioning holes and
the guide pins as shown in
Disassembly / Assembly
See Section 4.2.9 on page 54.
Positioning Hole
and Guide Pin
C.B.P. M4x12
(9±1 kgf.cm)
Left Hinge
Figure 4-55.
Disassembly Procedure
Revision A
62